FINDING THE MODEL & SERIAL NUMBER
On all Unitrol Products the Model & Serial Number can be found in the Instruction Manual that was shipped with your product. See below for how to find this information, if you no longer have your instruction manual or are unsure if your instruction manual matches the product.
On Welding Controls that have:
|
Remote Keypad Data Entry: |
|---|
|
|
Keypad or Thumbwheel Data Entry Mounted in Door or Left Side of NEMA 4 Enclosure |
|---|
|
|
Keypad or Thumbwheel Data Entry Mounted in NEMA 1 Bench Type Enclosure |
|---|
|
On Accustarts:
-
On label mounted on rear of Accustart
On Chillers:
-
On label mounted on front of chiller above water connections
FINDING THE SOFTWARE VERSION ON SOLUTION WELDING CONTROLS
On all Unitrol Welding Controls the SOFTWARE VERSION can be found in the Instruction Manual that was shipped with your product. See below for how to find this information, if you no longer have your instruction manual or are unsure if your instruction manual matches the product.
On all Models of Solution, Solution 2, & Solution 3 Phase Controls that are still under power:
Press the "PROGRAM" button then "86" then the "ENTER" button. The software version will show briefly on the display. Repeat the procedure as often as necessary until you get it recorded.
On Solution Welding Controls that are NOT under power:
|
Remote Keypad Data Entry (Solution, Solution 2, & Solution 3 Phase |
|---|
|
|
Keypad Data Entry mounted directly into Control Enclosure: Solution, Solution 2, & Solution 3 Phase |
|---|
|